Soon we will be able to offer our new Motorized TQ V4.
These will only be available in the GoldPlus format.
We have revised:
1. TQ now has a steel floor with attachment tabs.
2. All trim components have been redone and redesigned.
2.1. New electronics components for trim
2.2. New mechanical components for trim
2.3. New powerful engine for trim
2.4. Chain drive for Trim wheel (old version toothed belt can not transmit the high forces)
2.5. New power supply in the TQ (more power for the new Trim engine)
2.6. Better sound when trimming
3. Rev. 1 and 2 revised
3.1. Mechanical initial resistance about 2kg
3.2. strong latching points
3.3. Rev 1 and 2 are mechanically blocked!
3.3.1. Rev 1 and 2 are blocked in the air, they can not be pulled when Lever 1 and 2 are in Pos Idle.
3.3.2. If the aircraft is just above the runway when landing, Rev 1 and 2 can be pulled a little bit. To activate Rev 1 and 2.
3.3.3. Only when on the runway and when the indicators for Rev 1 and 2 in the Eicas change to the color green, the Rev levers are released and can be pulled.
3.3.4. Additional sensors have been added to activate Rev1 and 2.
4. The mechanical slip couplings for Lever 1 and 2 have been revised.
5. The TQ was mechanically stiffened once again
Products for your home cockpit for even more reality in your flight simulation.
Flight instruments for use in FSX, FS2004, Prepar 3D, XPlane10
For now, the flight instruments, gauge rudder position, gauge attitude, gauge altitude, gauge airspeed for the replica of the cockpit of the Boeing 737, in a few days the flight instruments are used for the overhead panel follow.
All flight instruments, individually or in combination, pre-assembled and tested.